Angle Slip Gauge

Calibration Standards Angle Slip Gauge

Angle Slip Gauges as per IS : 6231 – 1971 , designed for the inspection and calibration of angle, tapers, indexing plates, rotary scales, clinometers, dividing heads, rotary tables etc.
Materials
Angle Gauge Blocks are made from High Carbon High Chromium Steel which has the properties of aging stability in dimensions and wear resistance. The working surfaces are hardened to 800HV. Also Angle Gauge Blocks available in Tungsten Carbide.
Scope
These angle gauges together with the square block used to obtain any angle between 0 and 360 degrees in steps of 6 seconds.
Special Features

  • Accuracy measurement of any angle
  • No cumulative errors of division.
  • Wringing property similar to slip gauges.
  • High degree of reflectivity which enables them to be used with an autocollimator.
Set A 1 No. each 1, 3, 9, 27 & 41 Degrees

1 No. each 1, 3, 9 & 27 Minutes

1 No. each 6, 18 & 30 Seconds

1 No. Precision square block
Set A Set B 1 No. each 1, 3, 5, 15, 30 & 45 Degrees

1 No. each 1, 3, 5, 20 & 30 Minutes

1 No. each 6, 12 & 30 Seconds

1 No. Precision square block

Note: Any angle beyond 81° in the case of Set A and 90° in the case of Set B, can be obtained suitably using the precision square block of steel provided along with each set. The above sets along with the square block enable to be built up to 6 seconds, that is to within ±3 seconds of the required angle.

Slip Gauge Accessories are available in two sets 17 – pieces and 7- pieces

© 2024 El Shaddai Equipments

Design & Developed By InnovTouch Technologies